Brick Arch Viaduct

Brick and sandstone masonry in the style of an old railway viaduct: blind-arch retaining walls, a sloped wall, a stackable parapet and a configurable brick arch bridge for tracks and roads.

Edge addons (Tracks > Tools and Roads > Tools)

• Brick arch wall 5 m, 10 m and 20 m: blind arches in a sloped (battered) face
• Brick wall, sloped: plain battered wall
• Brick parapet: stack it on top of any of the walls

Brick arch bridge (Tracks > Assets and Roads > Assets)

• Snaps to the side of a track or road (hold SHIFT to place freely)
• Span 5 to 30 m (O / P), 1 to 10 arches ([ / ])
• Track version: 1 to 10 tracks. Road version: 4 to 40 m wide plus a 0.1 m fine adjustment
• Abutments at both, one or no ends, separate length for each end (0 to 40 m)
• Parapet on or off, snap along or across the edge
• All settings can be changed after placement

Brick arch wall (Landscaping > Assets)

• One asset that snaps to the side of both tracks and roads
• Length 1 to 100 m, height 3 to 20 m ([ / ])
• Blind arches 5 to 30 m wide, or none (O / P). Arches that are too tall for the chosen height are reduced automatically
• Flat or sloped face, parapet on or off
• Base terrain: levels the ground at the foot of the wall for 1 to 25 m (Off leaves the terrain untouched)
• Offset from the track / road: 0 to 20 m

Note: the assets do not snap to tracks or roads on bridges (a game limitation). Hold SHIFT to place them freely there.

Note: the game does not allow tracks or roads to pass under the arches. Use a collision-ignoring build mod (such as Build with collision) to lay them underneath.

Uses textures from the base game, so the mod adds no texture memory.

Disclaimer: this mod was created with the help of Claude (AI). Every piece has been heavily tested by hand in game to make sure there are no issues. If you still run into a problem, please report it in the comments.

Credits: the edge addon setup is based on DHE Walls & Tracks&Streets BETA, which was used as a reference.

Changelog:

Revision 2

• New: brick arch wall asset (length, height, arch width, flat or sloped face, parapet, base terrain levelling, offset from the track / road)

Revision 1

• Initial release