Dynamic Track Speed Limit

In Transport Fever 3 every track type has a fixed top speed. If you want a 160 km/h line to run at 110 through a curve, or a crossover at 30 km/h between two 60 km/h tracks, you normally need a separate copy of the track for every speed. Track Speed Limit lets you set the speed directly on the tracks you have built: pick the speed, click, done. The track keeps its type, its look and its catenary - only the maximum speed changes. FEATURES Track speed limit tool (Rail tools menu, next to Electrification) - Click a track segment to give it a speed limit, from 10 km/h up to the track's own maximum, in steps of 10 km/h. - Pieces 1-4: change up to 4 connected segments with one click, towards the side where you click. - A to B: click the first and the last piece of a stretch, and everything in between is changed - kilometres of line in two clicks. - Switches: click the point of a switch and only the diverging route is limited. On a crossover, the whole diverging route from switch point to switch point gets the limit, while the straight tracks keep their speed. - Restore mode puts the original track back. - Signals stay exactly where they are, catenary is kept. - The tooltip shows what will change before you click. Speed limit slider in the track build menu - Every track type in the game's track menu gets a "Speed limit" slider. - Build new tracks already limited, or use Replace Track (magic wand) to limit existing tracks - station tracks included. Speed limit slider in the station Configure menu - When you place a track module in a modular station, set its speed limit with the slider in the bottom bar. - No extra modules clutter the menu: the limited modules are hidden and only used when you choose a limit. Works with any track mod - The limited versions are generated automatically when the game loads, for the base game tracks and for every track mod you have active. - Track mods with their own ballast textures and catenary keep their look. HOW TO USE 1. Open the rail construction menu and pick "Track speed limit" (next to Electrification). 2. Set the speed with the "Speed limit" slider in the parameter panel. 3. Click a track segment, or the point of a switch. Use "Pieces" for several segments at once, or "A to B" for a whole stretch. 4. To go back to the original speed, switch "Mode" to "Restore" and click again. GOOD TO KNOW - Load this mod AFTER your track mods, so their tracks get limited versions too. - Do not remove the mod from a save where you used it: the limited tracks would be missing. - Not supported yet: nodes with 4 or more tracks (crossings, double slips - click the single segments instead) and the tracks of the Real Cant Engineering mod. - The mod writes its messages to the game log (stdout.txt), starting with [TrackSpeedLimit]. Please include those lines when you report a problem. Mod by Andrea Rizzo. Feedback and bug reports are welcome in the comments.